|
Alternative Tracks & Installation Methods As you have seen from the previous pages Aquamatic offer a range of cover systems to suit every pool. Listed below, isa range of alternative tracks available for these systems. All tracks are extruded from anodised aluminium and can withstand all weather conditions. *Advise your dealer if tracks are to be installed near salt water.
TOP TRACK - for new, existing or shaped pools.
The smooth contour design alleviates tripping and toe stubbing hazards! FLUSH TRACK - for new, existing or shaped pools.
Flush Track can also be installed on new, existing pools or shaped pools. This track extrusion is designed to be installed flush with either the paving surround or coping edge stones. FLUSH TRACK RECEPTOR STONES for Flush Track Only (Exclusive)
Flush Track Receptor Stones are available from stock in standard paving colours:- Buff, Grey, Terracotta, York Brown and White to match Coping Stones. Track Stones can also be colour matched to match your paving colours.*Custom made colours are a free of charge service! Allow 2-3 weeks for manufacture. GROOVE COPING STONES (9 & 12") for Flush Track Only (Exclusive)
Again, exclusively designed for Aquamatic, Groove Coping Stones replace the ordinary coping that are normally supplied with a pool kit. Groove Coping has a pre-formed gully built into the front edge of the coping that receives the flush track. Instead of having to place the track behind the coping, the track is now installed at the front edge of the coping. The main benefit to of using the Groove Coping system, is that 95% of the cover material is in contact with the water. Having more of the fabric material in contact with the water will result in less friction therefore, less wear & tear, quicker opening and closing times. The other benefits to consider are:- 1. There is no extra work for the pool installer to do, as he would of have to lay coping stones anyway! 2. There is no requirement to purchase the Trackstones! Groove Coping is a stock item and white in colour. Coping can be colour matched to your paving colours. *Surcharge applicable to custom made colours, allow 3 weeks for manufacture. If you are considering replacing your existing coping for new Groove Copings please bear in mind, most conventional coping are 2.5" thick at the front edge and taper down to 1.5" at the back edge. Groove Coping maintain the same depth (2") throughout the stone therefore, the new Groove Coping may be 0.5" higher than your existing paving levels (consult your pool dealer for advice, as a tile adhesive may be used to help reduce coping height). CONCRETE INWALL TRACK - for new pool construction only.
LINER INWALL TRACK - for new pool construction only. (Exclusive)
34mm STONE LID ADAPTOR EXTRUSION - for Inwall Track Only. (Exclusive)
The Stone Lid Adaptor Extrusion increases the height tolerance above the Inwall Track Receptor to enable a lid depth of up to 2"/50mm. Coping/Paving could be used for the pit housing lid on either a concrete or liner pool. Note. Increasing the lid depth using the Stone Lid Adaptor increases the 'freeboard' by 50mm. From the top of the lid housing to the water line, the depth will be approximately 209 - 234mm
|
 |
|
 |
;)
;)
Exclusively designed for Aquamatic our Flush Track Receptor Stones are
for installation on new or existing pools. They enable the pool builder
to install a pre-fabricated stone that has been designed to receive the
Flush Tracking. Installing the receptor stones ensure that correct
alignment and exact fit is achieved.
Almost every outdoor swimming pool that is built in this country has
either 9"or 12" white coping stones.
;)
;)
Stone Lid Adaptor Extrusion is designed for an Aquamatic installation
where a 2"/50mm stone pit housing lid is required. All pit housing lids
have a maximum lid depth of 20mm.
